How To Remove A Stuck Oil Filter? (3 Ways)

It can be difficult to install or remove an oil filter if you do not know the right steps. Although oil filters are easy to install, many customers find it difficult and time-consuming to take them out when they need to be replaced. This article will help you remove stuck oil filters. This is where we can help.

Before we move on to removing the oil filter let’s first examine what a stuck oil filters looks like. Let’s get started!

What is a stuck oil filter?

When someone mentions that the oil filter in your vehicle is stuck, there are two possible explanations. One, the outer layer of the oil filter is gone and the entire inner part is stuck. Two, the threads on the filter are stuck so that they cannot be removed or tightened. You can also experience this if the oil filter is used with a filter thread. bad or wrong oil filter For your car.

Both cases result in the oil filter getting stuck and cannot be easily removed with your naked hands. It is important to learn how to get rid of a stuck oil filter.

Let’s take a look at the video below!

How to Remove a Stuck Oil Filter

As with any stuck item, it can be difficult to remove an oil filter. We have seen that the oil filter can get blocked in two different ways. It is not possible to remove the oil filter by your hands.

There are several ways to get rid of the stuck oil filter.


While it is not recommended to use a wrench, or any other similar tool, to install or remove an engine oil filter. However removing stuck oil filters is possible. 

You just need a wrench to fit the oil filter’s inner cover if it doesn’t have one. Then, slowly rotate the oil filter anti-clockwise while not exerting too much force. You can find special oil filter wrenches in the marketplace.

Sand Paper

A wrench is not always able to remove stuck oil filters. It might slip again if you have a rubber oil filter wrench. Sandpaper is a better choice. Sandpaper provides a better grip for the oil filter.

Sandpaper by itself will not remove the oil filter blockage. You can remove the blockage by using a wrench. The sandpaper will provide a firm grip on the oil filter, preventing the wrench from sliding down.

Lubricating Fluid

After a long period of time, you might need to replace or change the oil filter. 

You can now remove the oil filter by spraying a lubricating liquid or spray on the block where the oil filter is stuck. You can then make the oil filter lubricate by spraying it. Alternatively, you can remove it using your hands or any wrench. 

Hammer and Screwdriver

The last option is to use a screwdriver and hammer to remove the oil filter.

Use a hammer with a screwdriver to remove the stuck oil filters. You will need to place the screwdriver near the oil filter block, then hammer the driver until it starts to get a bit in. 

Here are some things to keep in mind when removing a stuck oil filter.

Here are some tips to help you remove a stripped oil filter.

  1. Never be harsh and never apply too much force In the first instance, do not use the stripped oil filter. This could cause the filter to be crushed and make it more difficult to remove.
  2. After turning off the engine, do not remove the oil filter. This could cause you to have your hands cut.
  3. You should always have an oil pan and something nearby in case oil gets trapped.
  4. Only use a screwdriver and a hammer to remove stuck oil filters. Pulling off the filter could cause additional damage.


It is very difficult to get rid of a stuck oil filter because it may not have an outer cover or be blocked by threads. The above-mentioned methods can be used to remove stuck oil filters.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *